Device	Error Code	Description	Problem	Solution
DIAS	43 Flash	Maximum frequency exceeded	The sensor exceeded the max frequency	Inspect the sensor and cable Bad DIAS
DIAS	44 Flash	Timeout A/D converter		Bad DIAS
DIAS	45 Flash	Plasma not extinguished	The plasma suppression was unable to extinguish the plasma even with an axis sto More ...	Check the cutting process
DIAS	46 Flash	Plasma suppression inactive		Program Error
DIAS	47 Flash	Curve error	An error was detected while teaching the curve	Sheet moved? Nozzle bad, or loose? Bad Wiring?
DIAS	48 Flash	Sensor still in warm-up phase (max. 30s)	You just reconnected cutting head	Wait until it warms up 30 senconds
DIAS	49 Flash	Command rejected due to Feed Hold		Wiring error. Check DMP modules
DIAS	50 Flash	Nozzle collision during controller operation	Nozzle collision, poor cutting conditions, sensor has short-circuited	Eliminate the collision, correct the cutting parameters, eliminate the short-cir More ...
DIAS	51 Flash	Spatial frequency exceeded	Ceramic part loose, damaged or incorrectly set	Re-mount the ceramic part or, if necessary, replace it
DIAS	52 Flash	Target position too large	You are up too high above sheet to start curve teaching	Bring the cutting head down to sheet
DIAS	53 Flash	Manual output of analog voltage during regulation mode	That SOB tried to move.	Check I/O to DMP modules Replaced DIAS Replace Analog IN
DIAS	54 Flash	PMS or PCS pierce monitor inactive		Check PCS Sensor
DIAS	55 Flash	BiosPatch is missing
DIAS	56 Flash	+/-15V analog output error	The +/-15V supply to the analog is out of limits	Bad Sensor Board Replace DIAS
DIAS	57 Flash	+15V PC error	The +15V supply to the PC is out of limits	Replace DIAS
DIAS	58 Flash	-15V PC error	The -15V supply to the PC is out of limits	Replace DIAS
DIAS	59 Flash	Ground F counter error	The ground potential of the Positive edge at digital input frequency counter has More ...	Bad Sensor board Replaced DIAS
DIAS	60 Flash	CPU fan error	The CPU fan runs too slowly.	Replace CPU Fan
DIAS	63 Flash	Configuration error	The configuration data of the Profibus	Check Profibus Check System SW Configuration Replace DIAS
DIAS	64 Flash	Internal watchdog is triggered	Although the Profibus connection is ok no data is exchanged.	Check Profibus Replace DIAS

Any reference to TRUMPF machines, part numbers etc, are for reference only. Call for current pricing.