Device	Error Code	Description	Problem	Solution
DIAS	00 Flash	General error	Internal processes corrupt	Replace DIAS
DIAS	01 Flash	Insufficient main memory	Bad Memory	Replace DIAS
DIAS	02 Flash	Time basis setting error	Internal s/w corrupt	Replace DIAS
DIAS	03 Flash	Interrupt-Controller number error	Internal s/w corrupt	Replace DIAS
DIAS	04 Flash	Positive software limit	The (Z) axis has reached the positive software limit	Check slats, check software limit settings
DIAS	05 Flash	Negative software limit	The (Z) axis has reached the negative software limit	Check slats, check software limit settings
DIAS	06 Flash	Positive servo lag overshot	The distance axis has too great a contouring error in positive direction of the More ...	Check Axis for bind, or looseness. Check belt. Replace DMP module A8. Check for More ...
DIAS	07 Flash	Negative servo lag overshot	The distance axis has too great a contouring error in negative direction of the More ...	Check Axis for bind, or looseness. Check belt. Replace DMP module A8. Check for More ...
DIAS	08 Flash	Positive lag overshot	The distanced move does not match the command sent by DIAS	Check Axis for bind, or looseness. Check belt. Replace DMP module A8. Check for More ...
DIAS	09 Flash	Negative lag overshot	The distanced move does not match the command sent by DIAS	Check Axis for bind, or looseness. Check belt. Replace DMP module A8. Check fo More ...
DIAS	11 Flash	INI file error	software issue	Bad DIAS
DIAS	12 Flash	Errors in file	software issue	Bad DIAS
DIAS	14 Flash	No frequency change	Wrong freq values at calibration	Bad sensor cable bad sensor body Bad sensor board Bad DIAS
DIAS	15 Flash	Bad telegram	DIAS can't figure out telegram message sent	Check bibus fiber cables Clean fbir connection with Q-tip Bad profibus cable che More ...
DIAS	16 Flash	incorrect feedrate		Bad feedrate programmed
DIAS	17 Flash	incorrect cutting height		Bad stand off prograamed
DIAS	18 Flash	Incorrect piercing height	The piercing height is not within Input the correct piercing height the valid li More ...	Range: 0.3mm to 8.0mm (0.3mm-20mm)
DIAS	19 Flash	Invalid curve number
DIAS	20 Flash	Measuring range not reached	No sheet under the cutting head	Find a better position for cutting head
DIAS	21 Flash	Nozzle collision	Nozzle collision Eliminate the collision Poor cutting conditions Short-circuit More ...	Correct the cutting parameters Eliminate the short-circuit From software version More ...

Any reference to TRUMPF machines, part numbers etc, are for reference only. Call for current pricing.