Device	Error Code	Description	Problem	Solution
DIAS	22 Flash	Telegram buffer full	The internal telegram buffer is full	Check Bitbus Check Profibus Replace DIAS Replace TASC bitbus
DIAS	23 Flash	Telegram buffer empty
DIAS	24 Flash	Timeout		Replace DIAS
DIAS	25 Flash
DIAS	27 Flash
DIAS	28 Flash	General interface error		Replace DIAS
DIAS	29 Flash
DIAS	30 Flash	Lag error in curve teaching
DIAS	31 Flash
DIAS	32 Flash
DIAS	33 Flash	Sensor is unplugged
DIAS	34 Flash	Sensor short-circuit
DIAS	35 Flash
DIAS	36 Flash
DIAS	37 Flash
DIAS	38 Flash
DIAS	39 Flash	Temperature Exceeded	It's too hot	Lower temperature
DIAS	40 Flash	Drift voltage limits overshot	This is checked before moving. It's is a safety check. Z axis moved while being More ...	Bad A8 Analog In module. Defective DIAS (rare)
DIAS	41 Flash	Speed limit exceeded		Check drive system Loose belt, etc
DIAS	42 Flash	Minimum frequency undershot	The attached sensor did not attain the minimum frequency during curve teaching, More ...	Inspect the sensor and cable Bad DIAS

Any reference to TRUMPF machines, part numbers etc, are for reference only. Call for current pricing.